The basic method of marble repair

Production lines in the marble, and after cutting the blocks into plates, first to clean up dust, particles and other impurities, necessary,

to add heat to remove moisture. Apply glue to repair pits, blisters, chipping, cracks and other parts, filling, and then gelling. Rubber

conveyor belt in a continuous patch, you can also set the scratch sheet, in order to facilitate uniform patch, and a piece of a piece of

paper to be separated between the plate to prevent the plate bonding. Patch 2 ~ 4h after start curing adhesive, then leveled to the board,

best time is about to be leveled before curing, such as conditions permit, can also increase the heating devices, hot air and so reduce the

curing time. In recent years, some countries have developed a special glue on the marble equipment, eliminating a lot of human labor, and be

encouraged to use.

    Unsaturated resin reinforced with 307 agent, promoter, dye, or barite powder, prepared the original powder used in the patch glue repair

Slate pits, holes, cracks better. Such as patching holes through the sheet, first side surface of the marble pad of paper to this side of

the base surface provided anti-adhesive, filling, and then the other side of the pad of paper, eventually both sides of pad and Full. Be

cured rubber by grinding, patching will be better.